Micky R
Korpral-
Innehålls Antal
25 -
Gick med
-
Besökte senast
-
Dagar Vunna
1
Innehållstyp
Profiler
Articles
Media Demo
Forum
Bloggar
Kalender
Galleri
Filer
Butiken
Allt postat av Micky R
-
Äntligen en sugga
ämne svarade på Micky Rs Erling i Volvo Sugga/TP21/RAPTG 915/Volvo 912 och TL-varianterna
Looking good what colour green did you use -
Hi I have replaced the rotor arm now which was shorting out. The sugga has been out a few times now and seems ok so I think the rotor arm must have been breaking down fingers crossed this has fixed it . I used a megger tester to check through the ignition system
- 7 svar
-
- 1
-
Sugga Rotor arm
ämne svarade på Micky Rs Micky R i Volvo Sugga/TP21/RAPTG 915/Volvo 912 och TL-varianterna
- 4 svar
-
- 1
-
Hi Any one know of a replacement rotor arm for the Sugga mine is shorting out
-
I have an electric pump fitted and have cleaned the carb several times, it will drive for several miles then starts to slow down and then it will idle but when you try to pull away it lacks any power . I have washed the fuel tank out and fitted a filter after the pump it would be nice to keep the original Rochester carb
-
Volvo Sugga carburetor
ett ämne postade Micky R i Volvo Sugga/TP21/RAPTG 915/Volvo 912 och TL-varianterna
Hi any one know of an alternative carburettor for the sugga mine runs fine for a while then will not pull but will idle quite happily -
- 27 svar
-
- 1
-
Rear window winder
ämne svarade på Micky Rs Glynn i Volvo Sugga/TP21/RAPTG 915/Volvo 912 och TL-varianterna
- 2 svar
-
- 1
-
Hi any one know what ply rating Sugga tyres should be
-
- 27 svar
-
- 7
-
- 27 svar
-
- 2
-
sugga brakes
ämne svarade på Micky Rs Glynn i Volvo Sugga/TP21/RAPTG 915/Volvo 912 och TL-varianterna
Has any one fitted Toyota land cruiser wheel cylinders CS285 or CS286 to a Sugga as they look very similar -
sugga brakes
ämne svarade på Micky Rs Glynn i Volvo Sugga/TP21/RAPTG 915/Volvo 912 och TL-varianterna
Had a look under the sugga last night and my master cylinder is connected using the upper hole ,brake pedal travel isn't to bad. -
Hi the hinge I made was for the bottom one on the drivers door I will take some measurements and try to do a drawing. I made it by turning up the round part the pin goes through, cutting 2 flat plates and notching out the gap in the middle, the outer curved part of the hinge was made using a piece of heating pipe of the correct size cut into quarters this lot was then welded together. Hope this makes cense.
- 27 svar
-
- 1
-
Electronic ignition
ämne svarade på Micky Rs Glynn i Volvo Sugga/TP21/RAPTG 915/Volvo 912 och TL-varianterna
Hi which one did you fit from hot spark -
- 27 svar
-
- 3
-
Hi Sten Thanks my sugga runs but does not charge, So far I have repaired the bottoms of the front doors and made 1 door hinge. It has the radio tray still fitted. Mick
- 27 svar
-
- 5
-
New to owning a Sugga
ett ämne postade Micky R i Volvo Sugga/TP21/RAPTG 915/Volvo 912 och TL-varianterna
- 27 svar
-
- 8