[Äntligen en sugga]

Looking good what colour green did you use

[Volvo Sugga carburetor]

Hi I have replaced the rotor arm now which was shorting out. The sugga has been out a few times now and seems ok so I think the rotor arm must have been breaking down fingers crossed this has fixed it . I used a megger tester to check through the ignition system

[Sugga Rotor arm]

found this one fits the sugga

[Sugga Rotor arm]

Hi Any one know of a replacement rotor arm for the Sugga mine is shorting out

[Volvo Sugga carburetor]

Hi thanks will have a look tonight inside the carb

[Volvo Sugga carburetor]

I have an electric pump fitted and have cleaned the carb several times, it will drive for several miles then starts to slow down and then it will idle but when you try to pull away it lacks any power . I have washed the fuel tank out and fitted a filter after the pump it would be nice to keep the original Rochester carb

[Volvo Sugga carburetor]

Hi any one know of an alternative carburettor for the sugga mine runs fine for a while then will not pull but will idle quite happily

[New to owning a Sugga]

Have taken the back doors off to repair

[Rear window winder]

Hi hope these help Mick

[sugga tyres]

Hi any one know what ply rating Sugga tyres should be

[New to owning a Sugga]

Thanks still lots to do but now its driveable we can have some fun  

[New to owning a Sugga]

Second outing on the road

[New to owning a Sugga]

started fitting the lights

[sugga brakes]

Has any one fitted Toyota land cruiser wheel cylinders CS285 or CS286 to a Sugga as they look very similar

[sugga brakes]

Had a look under the sugga last night and my master cylinder is connected using the upper hole ,brake pedal travel isn't to bad. 

[New to owning a Sugga]

Hi the hinge I made was for the bottom one on the drivers door I will take some measurements and try to do a drawing. I made it by turning up the round part the pin goes through, cutting 2 flat plates and notching out the gap in the middle, the outer curved part of the hinge was made using a piece of heating pipe of the correct size cut into quarters this lot was then welded together. Hope this makes cense. 

[New to owning a Sugga]

Hi my Sugga came with a set of 5 part worn which used to be on a Dodge

[Electronic ignition]

Hi which one did you fit from hot spark

[New to owning a Sugga]

Front mud guards now repaired and painted

[New to owning a Sugga]

Hi Adam

 

I am based in Kent

 

 

Mick

[New to owning a Sugga]

 That will be great thanks

[New to owning a Sugga]

The one that goes on the passenger side

[New to owning a Sugga]

Hi every one thanks for the welcome  any one have any drawings or dimensions of the Ariel mounts that go on the bulkhead

[New to owning a Sugga]

Hi Sten Thanks

my sugga runs but does not charge, So far I have  repaired the bottoms of the front doors and made 1 door hinge. It has the radio tray still fitted.

 

Mick

[New to owning a Sugga]

New to the sugga world here is a picture of number463

Mick